YSE-200/250P
Power-off brake motor: its straight disc flow brake is installed on the end cover of the non-shaft extension end of the motor. Conditions of use: the altitude should not exceed 1000 meters, the maximum ambient temperature should not exceed 40°C, and the minimum temperature should not be lower than -15 °C.
A new type of brake motor specially designed according to the working needs of the crane, suitable for: electric single girder, hoist double girder, gantry crane
length of work
Lightweight body
high temperature
The working principle of YSE series soft start brake motor (III generation) is that when the motor is connected to the power supply, the rectifier of the brake is connected to the power supply at the same time. Due to the action of electromagnetic suction, the electromagnet attracts the armature and presses the spring, the brake disc and the armature and the end cover are removed, and the motor runs; When the power is cut off, the brake electromagnet loses its electromagnetic attraction, and the spring force pushes the armature to press the brake disc. Under the action of friction torque, the motor stops running immediately.
This series of motor junction box is installed on the top of the motor, the motor mounting hole spacing is the same, according to the installation requirements, the motor can be rotated 2~180° direction installation.
This series of motor has greatly reduced noise and vibration, and has reached the advanced level, equipped with high-performance protection level (IP54), improve the insulation level of the motor and increase the service life of the motor;
The design of this series of motors pays special attention to the appearance of beautiful appearance, the design of the heat sink bar vertical, horizontal distribution, end cover, wiring wind hood are improved design, the appearance is particularly beautiful.
Four advantages/YSE series outstanding features:
Soft starting Walking without impact.
Strong starting power Can work continuously for 8 hours.
Lightweight and energy-saving 1/4 current start energy saving and environmental protection.
Strong practicality Adapt to high temperature environment operation.
Type | Power (D.KW) | Torque (D.N.M) | Stall Current (D.A) | Rated Speed (r/min) | Brake Torque (N.M) | Flange plate (Ф) | Mounting stop (Ф) | Length (L) | |
Standard Style | YSE 802-4P | 0.8KW | 8 | 3.6 | 1200 | 1-5 | 220P | Ф130 4-Ф12 through-hole | 220 |
YSE 90S-4P | 1.1KW | 12 | 6.2 | 1200 | 250 | ||||
YSE 90L-4P | 1.5KW | 16 | 7.5 | 1200 | 250 | ||||
YSE 100L1-4P | 2.2KW | 24 | 10 | 1200 | 3-20 | 250P | Ф180 4-Ф15 through-hole | 290 | |
YSE 100L2-4P | 3KW | 30 | 12 | 1200 | 230 | ||||
YSE 100L3-4P | 4KW | 40 | 17 | 1200 | 340 |
Note: The above is the driving standard configuration, such as special use conditions, please choose another, level 6, 8, 12
Selective configuration | Hard boot | High power | Different voltage | Frequency conversion | Special tooth | Variable stage multispeed | Non-standard | Encoder |
Note: The data in the table is for reference only, according to the working condition, wheel and other data changes, subject to the actual objects and drawings. Voltage can be set 200V-480V 50Hz-60Hz, can choose two-speed, multi-speed combination, such as 4/8 pole, 4/12 pole.